I assume there are no issues omitting these two partitions unless I wanted to revert to factory settings. Is there any way to prevent the internal SSD from overheating (getting above 70 degrees Celsius) when doing a backup with software like Macrium Reflect?Ĥ) Since the original SSD is 1024.2gb, I had to omit the "recovery" and "restore" partitions when cloning to a standard 1TB NVME SSD (1000gb). Do I need a strip of metal added to the new SSD? If so, where do I get a new strip of metal to attach to the new SSD, as I don't want to pry the strip of metal off the old SSD.ģ) I notice (via CrystalDiskInfo) that the old SSD tends to overheat when doing a fast backup (and that's even when backing up to an old fashioned Sata hard drive via USB3). I assume this is for EMF interference protection.ġ) Do I really need that aluminum sleeve on the new drive?Ģ) I also notice the old drive has a strip of metal attached to the top of the original SSD. I can slide the old sleeve off and put the new SSD in the foil sleeve. Choose the Destination Drive: Next, select your SSD as the destination drive. What you'll need An SSD, of course In addition to getting a drive with the right form factor and interface, you'll want to get an SSD with at least enough room for the Windows partition and. This drive will be the one from which all the data will be copied. Connect the SSD to your computer via the SATA-to-USB adapter. Plug in SSD on Your PC and Initialize It. You can use a free backup tool - EaseUS Todo Backup to back up data on your hard drive. I notice the old drive has a foil sleeve around it. Select the Source Drive: In the cloning software interface, select your existing hard drive (the one you want to clone) as the source drive. And if your SSD is not new, you need to back it up because the cloning process will erase data on the target drive. My plan is to do one more backup to a newer SSD and then swap again. My plan is to replace the original 1024.2 GB SSD with a 1000gb (1TB) SSD.Īs a test, to see if the laptop would boot off of a clone of the original SSD, I removed the cover and swapped out for a backup drive and it worked, but I put the old drive back for now. In this video, I show you how to clone your laptop hard drive over to a new solid-state drive. I'm concerned about these errors even though it still says it has 97 percent of the spare blocks. The laptop in the video is a Dell Inspiron 17 5767.Links:SATA. Chkdsk found and repaired some issues with some old email files, but repaired them (and I restored the ones that had data loss). Yesterday (Thurs) it got 34 more of these errors. First off to actually 'clone' your HDD to an SSD, you have to shrink the largest partition on the HDD so that the total of ALL the partitions can easily fit onto the SSD. I did another full backup on Wednesday and the number of Media and Data Intergrity Errors went to around 425. It had 4 entries for the past 6 months from when I backed up the drive using a fast backup program. My 1.5 year old ASUS TUF GAMING F15 FX507ZM (2022) has lately been getting Media and Data Integrity Errors according to CrystalDiskInfo.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |